9mm 115 FMJ RN

Just ordered another 2,000 FMJ Rn. I have been shooting these for a long time with great satisfaction.

My recipe is RMR 115gn FMJ Rn with a CCI 500 primer and 6.4 gn of HS-6 with an OAL of 1.100”. This is kind of on the low end of published data but it cycles all my 9mm guns flawlessly. Out of my czP10c the chronograph shows right around 1200 FPS.
Shoots very accurately, low recoil impulse, low flash, not much smoke. And the Dillon 650 makes them almost as fast as I can shoot them.

I’ve shot thousands of 9mm FMJ RN through multiple guns. I do a lot of competitive USPSA.

For my PCC load, I use 4.4gr of Sport Pistol under a 115 @1.125”. This gets me right around 140PF which id about 1200fps out of a 16” barrel

I also use these for shooting Open division. I used 10.4gr of Shooters World Major Pistol under a 115fmj rn @ 1.180” and a small rifle primer. This gets me about 1500fps out of a 5” barrel with 2 3/16” ports. I do NOT recommend this recipe for the average shooter/gun unless you know what you’re doing…

Another powder I use is HS6. 8.8gr at 1.180” again. Makes major power factor no problem!

My favorite load that woks well is a Win SP or Federal SP primer with 7.2 grains Power pistol @1.12 OAL.

RMR 115gr RN
Mixed brass
4.4gr Titegroup powder
CCI small pistol primer
1.150 OAL

I did a test of this load across various pistols; measured with my Labradar cronograph. Results were as follows:

3.7″ barrel = 1150 fps
4.7″ barrel = 1198 fps
4.9″ barrel = 1209 fps
8.3″ barrel (also had a suppressor attached) = 1295 fps