Home › Forums › Reloading Database › 115 JHP n Titegroup
- This topic has 5 replies, 5 voices, and was last updated 1 year, 9 months ago by
cbmay48.
-
AuthorPosts
-
February 5, 2022 at 8:10 am #407433
Rick Godwin
ParticipantI ordered 115 FMJ n Received 115 JHP. My question is I use Titegroup to reload n can I still use it for the 115 grain JHP. If so I use 3.9 to 4.0 powder. Can I still use this load for the 115 grain JHP ?
February 14, 2022 at 2:14 pm #409798James Morris
ParticipantI would use 4.4 gr. with hollow points. It works.
-
This reply was modified 3 years, 2 months ago by
James Morris.
July 14, 2022 at 6:32 pm #442355johnandterry
ParticipantAny chronograph #’s for 4.4 gr Titegroup. The highest published amt. I’ve seen is 4.2. It would be nice to see a little higher velocity.
July 14, 2022 at 6:33 pm #442357johnandterry
ParticipantNever mind, I’m thinking of 124 gr bullets.
July 10, 2023 at 8:53 am #4963851kevinmason
ParticipantI ordered the 115 grain JHP and using the Silhouette powder, I can not find any load data for them. I am new to loading and i do not want to make a bad mistake being new to it.
Is there anywhere I can find this data, OAL, Charge Etc.July 17, 2023 at 3:16 pm #496598cbmay48
Participanthttps://www.hodgdonreloading.com/reloading-data-center
I haven’t used Silhouette yet, but I would use the data for the Nosler 115 gr JHP bullet, as it is similar to the RMR bullet. Start low and work up, watching for pressure signs. -
This reply was modified 3 years, 2 months ago by
-
AuthorPosts
- You must be logged in to reply to this topic.